3M 7000R Instructions And Parts List page 36

7. Installation
7. Hold taping head Buffi ng Roller and
8. Check for free action of both upper
9. Ensure that the tape drum bracket
Buffi ng
Roller
3M-Matic 7000r-7000r3 Pro
™
Page 24
(continued)
cut and remove cable tie that holds
applying/buffi ng arms retracted
(Applying/buffi ng rollers are held
retracted for shipment - Figure 7-6).
Allow buffi ng/applying arms to
extend slowly.
Also cut and remove cable tie at
rear of lower taping head.
and lower taping heads. Push
buffi ng roller into head to check for
free, smooth action of taping heads.
assembly, located on the lower
taping head, is mounted straight
down (Figure 7-8). The tape drum
bracket assembly can be pivoted
to provide tape roll clearance in
certain cases.
C
Cable
Tie
B
Figure 7-7 7000r-7000r3 Pro Frame Set-Up
WARNING
• To reduce the risk associated with
sharp blade hazards:
- Keep hands and fi ngers away from
tape cutoff blades under orange blade
guards. The blades are extremely
sharp.
Column Guards
A
Note:
Column Guads are
removed before Installing
the Bumper Supports.
Column Guards are
then installed.
NA - ENG
April 2016