Safety Devices; Blade Guards; Emergency Stop Button; Electric System / Circuit Breaker - 3M 7000R Instructions And Parts List

10. Safety Devices of the Machine

10.1 Blade Guards

10.2 Emergency Stop Button

10.3 Electric System / Circuit Breaker

3M-Matic 7000r-7000r3 Pro
™
Page 36
Both the top and bottom taping
units have a blade guard
(See Manual 2 or 3: AccuGlide™ 3
Taping Heads - 2" or 3".
The box drive belts are turned on
and off with the electrical switch
on the side of the machine frame
(Figure 10-1).
- To restart machine, rotate the
emergency stop switch clockwise
to release the switch latch.
Restart machine by turning the
On/Off switch to Off position and
then to On position (Figure 10-2).
- Then press the Station "Start"
Button (Figure 10-3) .
The electric system is protected by
a ground wire whose continuity has
been tested during fi nal inspection.
The system is also subject to insula-
tion and dielectric strength tests.
Note: The case sealer has a circuit
breaker located in the electrical
enclosure on the machine frame.
If circuit becomes overloaded and
circuit breaker trips, unplug the
machine electrical cord and
determine cause of overload.
After two minutes, reset the
circuit breaker. Plug machine
electrical cord into outlet and
restart machine by Turning the
On/Off switch to the On position.
1. Determine cause of overload
and correct.
2. Plug in machine.
3. Turn machine switch "On" (I)
to resume case sealing
Important: The use of an extension
cord is not recommended.
However, if one is needed for
temporary use, it must:
• Have a wire size of 1.5mm
diameter [AWG 16]
• Have a maximum length of
30.5m [100 ft]
• Be properly grounded.
Figure 10-1
Figure 10-1
"On-Off "
Figure 10-2
WARNING
•
To reduce the risk associated with
sharp blade hazards:
−
Keep hands and fi ngers away from tape
cutoff blades under orange blade guards.
The blades are extremely sharp.
WARNING
• To reduce the risk associated with
hazardous voltage:
− Position electrical cord away from foot
and vehicle traffi c.
WARNING
• To reduce the risk associated with
mechanical and electrical hazards:
− Allow only properly trained and qualifi ed
personnel to operate and service this
equipment.
E-Stop
"Start/Stop"
Figure 10-3
NA - ENG
April 2016