Special Set-Up Procedure - Outer Column Repositioning - 3M 7000R Instructions And Parts List

13. Maintenance and Repairs
13.12 Special Set-Up Procedure for
A
3M-Matic 7000r-7000r3 Pro
™
Page 48
Outer Column Re-Positioning
(continued on next page)
Moving the outer columns will
increase/decrease the maximum
box height capacity of the 7000r-
7000r3 case sealer.
1. On both sides, place a solid
spacer block (as needed to
support column and to help
line up new holes) between
fl oor and bottom of outer
column (Figure 13-8A).
2. On both front and rear, place
solid spacer blocks (14" [355mm])
and lower the upper taping head
assembly until the upper assembly
rests on blocks.
3. Remove eight (8) column screws
(Figure 13-8B).
4. Place second spacer block under
column (Figure 13-8A).
5. Re-attach/tighten the eight (8)
screws and washers in each
column (Figure 13-8B).
6. Remove existing guard and attach
inner guide plate using hardware
provided (Figure 13-8B).
(continued)
Figure 13-8
Upper
Assembly
Spacer(s)
Column Spacer (#2)
Column Spacer (#1)
(continued)
Important! When the column is
B
in the upper position, the
Inner Column Guard must
be installed (Figure 13-8B).
WARNING
• To reduce the risk associated with
mechanical and electrical hazards:
- Turn peumatic and electrical supplies off
and disconnect before performing any
adjustments, maintenance or servicing
the machine or taping heads.
WARNING
• To reduce the risk associated with
muscle strain:
− Use the appropriate rigging and
material handling equipment when
lifting or repositioning this equipment
• To reduce the risk associated with
impact hazards:
− Always use appropriate supporting
means when working under the
upper drive assembly
Note:
Remove
Column
Screws
Inner
Guard
replaces
existing
Guard
NA - ENG
April 2016