3M 7000R Instructions And Parts List page 28

4. Specifi cations
(To relocate upper frame or outer columns, see "Special Set-Up Procedure")
Case Height Range Illustration:
A. Standard Machine Position: Outer Columns positioned against Stop with Upper Drive
B. Raised Machine Position:
C. Lowered Machine Position:
Boxes narrower than 8" [200mm] may require more frequent belt replacement because of
limited contact area.
Special modifi cations may be available for carton sizes not listed on previous page.
Contact your 3M Representative for information.
Note: The case sealer can accommodate most boxes within the size range listed above.
3M-Matic 7000r-7000r3 Pro
™
Page 16
(continued)
Minimum/Maximum Box Height Combinations
Minimum / Maximum
115mm
[4 1/2"]
Operating
Range
Standard Machine Position:
Outer Column against Stop /
Upper Assembly - Lowest
Position on Inner Column
Minimum / Maximum
57.15mm
[2 1/4"]
Operating
Range
Lowered Machine Position:
Columns and Upper
Assembly in lowest postion /
Column bumpers removed.
However, if the box length (in direction of seal) to box height ratio is .6 or less,
then several boxes should be test run to assure proper machine performance.
Any box ratio approaching this limitation should be test run to assure performance.
DETERMINE THE BOX LIMITATIONS BY COMPLETING THIS FORMULA:
BOX LENGTH IN DIRECTION OF SEAL = SHOULD BE GREATER THAN .6
BOX HEIGHT
A
660mm
[26"]
Box
Box
C
647.7mm
[25 1/2"]
Box
Box
Assembly set to Lowest Position on Inner Columns.
Tape Leg Length - 2 3/4" [70mm].
Maximum Box Height (i.e. Outer Columns and Upper Drive
Assembly in Highest Position - See Special Set-Up Procedure).
Tape Leg Length - 2 3/4" [70mm].
Lowest Box Height, columns in lowest position heads in
off set position, Tape leg length 2", Upper assembly in
lowest position, column bumpers removed.
Minimum / Maximum
317mm
[12 1/2"]
Operating
Range
Note: Length of boxes in illustrations
are not to scale.
B
914mm
[36"]
Box
Box
Outer Column:
Fully Raised
Position
NA - ENG
April 2016