Special Set-Up Procedure; Changing Drive Belt Height - 3M -Matic AccuGlide 2+ 800af Instructions And Parts List

14 - SPECIAL SET-UP PROCEDURE

WARNING
•
To reduce the risk associated with
pinches and entanglement hazards:
−
Do not leave the machine running
while unattended.
−
Turn the machine off when not in use.
−
Never attempt to work on any part of
the machine, load tape, or remove
jammed boxes from the machine while
the machine is running.

14.1 Changing Drive Belt Height

The drive belt assemblies can be raised 50mm
[2 inches] to provide better conveying of tall boxes.
This change increase the minimum box height that
can be taped to 190mm [7-1/4 inches].
Disassembly – Figure 14-1
1. Using the height adjustment crank, raise the
upper taping head to its fully raised position.
2. Remove and retain the M6 x 16 fl at head cap
screw (A), special washer (B) and spacer (C)
from the front and rear arm assembly pivots.
3. Lift drive belt assembly (D) up off the arm
assembly pivots.
Note – Keep motor in vertical position to prevent
gear oil from leaking out of motor.
Reassembly – Figure 14-2
4. Reassemble the spacer (C) onto the front and
rear arm assembly pivots fi rst.
5. Install the belt drive assembly (D) onto the pivots
and secure with special washers (B) and M6 x
16 fl at head cap screws (A).
Note – Both drive belt assemblies must be installed
at the same operating height.
800af-I-NA
Figure 14-1 – Drive Belt Height, Disassembly
Figure 14-2 – Drive Belt Height, Reassembly
43
A
B
C
D
A
B
D
C
2010 December