Operation; Operator's Correct Working Position; Starting The Machine; Starting Production - 3M 7000R Instructions And Parts List

12. Operation

12.1 Operator's Working Position and

12.2 Starting the Machine

12.3 Starting Production

12.4 Tape Replacement and Threading

12.5 Box Size Adjustment

12.6 Cleaning

12.7 Table of Operation Adjustments -
1 Tape loading and threading
2 Tape web alignment
3 Adjustment of one way tension roller 1
4 Adjustment to box size (H and W)
5 Top fl ap compression rollers
6 Adjustment of tape applying spring 1
7 Conveyor bed height adjustment
8 Special Adjust-Changing tape leg
9 Special Adjust-Column re-position 2
3M-Matic 7000r-7000r3 Pro
™
Page 39
Operational Flow (Figure 12-1).
Once the box has been fi lled,
close its top fl aps and push it
between the top and bottom
drive belts. Always keep hands
in position as shown in Figure 12-2.
The box will be automatically sealed
with adhesive tape on top and bot-
tom box seams. Then the box will
be expelled on the exit conveyor.
Important: Before starting the
machine, verify that no tools
or objects are on conveyor bed.
Let the machine run without cartons
and check its safety devices. Then
start the working cycle.
After adjusting machine to box
dimensions (height-width), let
machine run without cartons and
check safety devices. Then start
working cycle.
See Manual 2 or 3: AccuGlide™ 3
Taping Heads - 2 Inch or 3 Inch.
Press the LATCHING EMERGENCY
STOP BUTTON.
Repeat all the operations shown in
Section 11 - Set-Up/Adjustments.
Before carrying out cleaning or
maintenance operation, stop the
machine by turning OFF (O) switch
on main and disconnect pneumatic
and electric power (Figure 12-3).
Operator Qualifi cations
Figure 12-1
Position
Figure 12-2
Figure 10-1
Figure 12-3
"On-Off "
1
1
Figure 12-4
1
1

12.8 Safety Devices Inspection

1 1. Taping units blade guard
2. Latching emergency stop button
2
3. STOP (OFF) (O) main switch
Hand
E-Stop
"Start/Stop"
Figure 12-5
NA - ENG
April 2016