Cutting Width Correction Function - YASKAWA YRC1000 Instructions Manual

HW1483590
3.3
3 Teaching
3.3

Cutting Width Correction Function

Cutting Width Correction Function
The cutting width correction function shifts the scale of the cutting width of
the laser for the cutting path when cutting the form according to the
pattern. The following parameter is used for the setting.
Parameter
S3C1191
Set the cutting width of the laser to 1/2 of its value. When cutting, the path
is corrected by the parameter set values.
The following illustration is an example of the path correction when cutting
the ellipse pattern. The correction for the motion path is similar when
using the other patterns.
The center of the circle does not change before and after the cutting width
correction.
3-6
Contents
Cutting width correction
(in units of 0.001 mm)
When the cutting width correction value is (+)
When no cutting width correction
When the cutting width correction value is (-)
The set value at S3C1191
HW1483590
Initial Value
0 mm
15/49