Planet Networking & Communication WGSW-48040HP Command Manual page 24

4. Repeat step 1 to check if the IP address is changed.

Store current switch configuration
5. At the "#" prompt, enter the following command and press <Enter>.
# copy running-config startup-config
If the IP is successfully configured, the Managed Switch will apply the new IP address setting immediately. You can access the
Web interface of the Managed Switch through the new IP address.
If you are not familiar with the console command or the related parameter, enter " ?" anytime
in console to get the help description.
Figure 2-7: Saving Current Configuration Command Screen
Command Guide of WGSW-48040HP
-24-