Neighbor; Table 102 Neighbor Command - Nokia 7302 Basics, Management And Oam Manual

Monitor Commands
5.3.4.7
Table 102
Sample output:
A:ALA-12>monitor>router# ospf neighbor 10.0.0.104 interval 5 repeat 3 absolute
============================================================================
Monitor statistics for OSPF Neighbor 10.0.0.104
============================================================================
At time t = 0 sec (Base Statistics)
----------------------------------------------------------------------------
Bad Nbr States : 0
Bad Seq Nums : 0
Bad Packets : 0
Option Mismatches: 0
----------------------------------------------------------------------------
At time t = 5 sec (Mode: Absolute)
----------------------------------------------------------------------------
Bad Nbr States : 0
Bad Seq Nums : 0
Bad Packets : 0
Option Mismatches: 0
----------------------------------------------------------------------------
100

neighbor

neighbor command
Item Description
Syntax neighbor interface [interface...(up to 5 max)] [interval seconds] [repeat repeat] [absolute |
rate]
Context monitor>router>ospf
Description This command displays statistical OSPF or OSPF3 neighbor information at the configured
interval until the configured count is reached.
The first screen displays the current statistics related to the specified neighbor(s). The
subsequent statistical information listed for each interval is displayed as a delta to the previous
display.
When the rate keyword is specified, the "rate per second" for each statistic is displayed instead
of the delta.
Monitor commands are similar to show commands but only statistical information displays.
Monitor commands display the selected statistics according to the configured number of times
at the interval specified.
Parameters neighbor ip-address — Displays damping information for entries received from the BGP
neighbor. Up to 5 IP addresses can be specified.
interval seconds — Configures the interval for each display in seconds.
Default: 10 seconds
Values: 5 — 60
repeat repeat — Configures how many times the command is repeated.
Default: 10
Values: 1 — 999
absolute — When the absolute keyword is specified, the raw statistics are displayed, without
processing. No calculations are performed on the delta or rate statistics.
rate — When the rate keyword is specified, the rate-per-second for each statistic is displayed
instead of the delta.
3HH-11982-AAAA-TQZZA
"FD 100/320Gbps NT and FX NT IHub System
LSA Inst fails : 0
Bad MTUs : 0
LSA not in LSDB : 0
Nbr Duplicates : 0
LSA Inst fails : 0
Bad MTUs : 0
LSA not in LSDB : 0
Nbr Duplicates : 0
Basics, Management and OAM Guide"
Issue: 10