Create Reports - FAG Detector III Manual

At the top of the window you can select the time range, which you want to send the
data for. If you have unchecked the Time range checkbox all previous data will be
sent.
Enter at Data to be exported, which data shall be transferred. If no data can be
sent via this selection anymore, i.e. if you want to send alarms only, but no alarms
are in the selection, the OK button will be disabled.
· Click on OK now to send the data. Depending on your e-mail settings the data
are transferred immediately or they are copied into an Outlook mail, which you
will have to send manually.

3.12 Create reports

The Trendline software offers the following report types:
· The measurement report
measured values for the sensors defined in the configuration in tabular and
graphic form.
· You can use the alarm report
alarms that have accumulated to date for freely selectable elements in your
configuration.
· The route report
measurement signals for a given route in the form of checklists. You can
systematically and reliably "work through" the measuring point of a route with
the aid of the route report.
· The balancing report
measurements carried out for one element of your configuration.
· The run up/coast down report
configuration settings and the associated amplitude/phase diagrams.
provides a comprehensive overview of the
96
to create an overview of preliminary and main
100
presents all measuring points and corresponding
102
provides you with a clear overview of balancing
102
creates an overview of the run up/coast down
104
Trendline 3
95