Create Template - FAG Detector III Manual

In this window you must select the route you want to print in the route report.
In this window you can select the route you want to display in the report.

3.6.2 Create template

A template is a pattern for free measurements, i.e. measurements which are not
in the current route.
You can send up to five templates for free CM measurements,
balancing templates, and run up / coast down tests in a route.
A template has the same layout as a measuring point. As with a measuring point,
time signals can be recorded and different characteristic values set. If you want to
associate a free measurement with a certain measuring point, the template for this
measurement must have the same layout as the respective measuring point. That
means, the same characteristic values (with the same cut-off frequencies) must be
set and the sensor must correspond as well. Time signals and alarm thresholds
may differ, as the characteristic values can be compared none-the-less.
· To create a new template, click in the Planning-menu on Template.
Trendline 3
83