Download Data From Detector - FAG Detector III Manual

· Select the route you want to send to the Detector.
· If you check the checkbox Send Template, you can select one of the previously
defined template groups.
· Connect the Detector with the data cable to your PC and switch it on.
· Click OK to send the route to the Detector.
Another way of sending a route to the Detector is directly from route planning (
Planning > Route). Click on
exactly as described above.
If the "Always save" option is marked for a greater number of
measurement points in the route you wish to send to the Detector
than are permitted in the Detector memory an error message will be
output and the data will not be transferred. Also refer to System
messages and their meaning

3.7 Download data from Detector

After measuring with the Detector you have to transfer the data to Trendline 3
software. Connect the Detector with the data cable to your PC and switch it on.
Click on Detector > Load data from Detector or on
configurations, time signals and free measurements, are downloaded onto the PC.
This process can take several minutes depending on the amount of data.
Once all data have been received, they are stored at the respective locations in
the database. It can happen that the program does not automatically sort the
measuring points, e.g. you have taken free measurements or the configuration on
the Detector had been created on a different PC. In this case, the sorting wizard
will be started automatically for sorting the measurements into your
86
configuration tree.
. The Send route window opens. Then proceed
.
205
Trendline 3
. Now, all data, that is
85