Balancing Activation - FAG Detector III Manual

3. Close the Device manager.
Removing the adapter software
The adapter software can be removed as follows:
1. Click on Start, click on Control panel and then click on Software.
2. Click on Modify or remove program then click on PL-2303-USB-to-Serial.
3. Click on Modify/remove to uninstall the software.

3.3.3 Balancing activation

The Detector III is supplied ex works with the balancing functionality switched off.
You can enable this function if you have purchased a Detector III balancing kit.
The balancing kit contains a USB dongle which can be used to enable one unit
only.
This activation is essentially carried out as follows:
· A dongle is supplied with the balancing kit that has not previously been used.
· You can use this dongle to enable the balancing functionality for only one
Detector which can be selected at will.
· Once enabled, the serial number of the Detector is saved on the dongle. From
this point onwards the dongle may only be used with this specific Detector.
· You can also deactivate the balancing functionality in the Detector once again
38
Dongle