Export A Measuring Point - FAG Detector III Manual

3.13.3 Export a measuring point

You can export the data assigned to an individual measuring point to a text file to
edit them with another program. The Trendline software saves the export files in
one or several files in CSV format ("comma separated values"), i.e. data on a line
are separated by commas. You can open files in CSV format with any common
spreadsheet software to get a clear overview of the data in a table.
In addition to the measuring point data proper, the Trendline software also saves a
file called "VersionInfo.csv" containing details on the program version and the
database used.
Proceed as follows to save a measuring point:
· Click on the measuring point in the configuration tree.
· Click on File > Export > Measuring Point.
· Select the directory where you want to save the file and enter a file name. The
program automatically adds the .csv ("comma separated variables") extension.
· Click on OK to export the data.
Below is a description of the contents of the export file depending on the type of
measuring point.
Measuring point from a Cm configuration
If you export a measuring point from a CM configuration, the Trendline software
saves a general export file with details of the configuration and other files with the
time signals.
The general export file contains a line for each measurement containing the
following:
Heading
idx
State
Timestamp
Velocity
Acceleration
Demodulation
Data x
Name x
Type x
Prealarm x
106
Contents
Measurement identification number.
Alarm Status: 0 – no alarm, 1 – pre-alarm, 2 – main alarm
Measurement timestamp.
Export file with velocity time signal (the signal is an acceleration signal, see
alsoTime signals 211 ").
Export file with the acceleration time signal.
Export file with the demodulation time signal.
Characteristic value measured
Name of characteristic value
Type of characteristic value
Pre-alarm threshold in % of the main alarm threshold.
.
15