Editing / Deleting Sensors - FAG Detector III Manual

an Alarm. Additionally, a preliminary alarm threshold can be set in Trendline
software. If the measured value exceeds this threshold, preliminary alarm is given
for this measuring point in Trendline software. The Detector shows main alarms
only. Prealarms are only displayed in Trendline.
See also
Reset alarm status .
92

3.4.5 Editing / deleting sensors

If you have added custom sensors in addition to the pre-defined sensors, you
34
can edit or delete them. However, this is only possible if the sensor is not being
used in a configuration!
Editing a sensor
· In the Detector menu click Sensor > Edit.
· Select the sensor in the Edit sensor window.
· Edit the settings (see also Add sensor ) and click OK.
34
If the sensor is in use, the input boxes are grayed out and you cannot edit them.
Deleting a sensor
· In the Detector menu click Sensor > Delete.
· Select the sensor to delete in the Delete sensor window and click OK.
If the sensor is in use, this is displayed in the window and you cannot delete it.
3.4.6 Managing measurement comments
In the Trendline software you can create short texts as measurement comments.
The comments list is synchronized whenever data are exchanged with the
Detector. During the measuring round, you can assign a comment from the list to
every measurement on the Detector. The comment is saved with the measurement
and displayed in the measuring results in the Trendline software. You can then edit
the comment if necessary (see "Measured data ").
88
52