Messages And Parameters - Siemens SINAMICS S120 Series Function Manual

6.8

Messages and parameters

Faults and alarms (see SINAMICS S120/S150 List Manual)
• F01910
• A01925 (F)
• F08501 (N, A) PN/COMM BOARD: Setpoint timeout
• A08526 (F)
• A08555
Overview of important parameters (see SINAMICS S120/S150 List Manual)
• p0978[0...n]
• p2030
• p2040
• r2050[0...19]
• p2051[0...24]
• r2053[0...24]
• r2054
• p8835
• p8839[0...1]
• p8840
• r8850[0...19]
• p8851[0...24]
• r8853[0...24]
• r8854
• p8920[0...239]
• p8921[0...3]
• p8922[0...3]
• p8923[0...3]
• p8924
• p8925
• p8940[0...239]
• p8941[0...3]
• p8942[0...3]
• p8943[0...3]
• p8944
• p8945
Communication
Function Manual, 12/2018, 6SL3097-5BD00-0BP0
Fieldbus: Setpoint timeout
Modbus TCP connection interrupted
PN/COMM BOARD: No cyclic connection
Modbus TCP commissioning fault
List of drive objects
Fieldbus interface protocol selection
Fieldbus interface monitoring time:
CO: IF1 PROFIdrive PZD receive word
CI: IF1 PROFIdrive PZD send word
IF1 PROFIdrive diagnostics PZD send word
PROFIBUS status
CBE20 firmware selection
PZD interface hardware assignment
COMM BOARD monitoring time
CO: IF2 PZD receive word
CI: IF2 PZD send word
IF2 diagnostics PZD send
COMM BOARD state
PN Name of Station
PN IP address
PN default gateway
PN Subnet Mask
PN DHCP mode
PN interfaces configuration
CBE2x Name of Station
CBE2x IP address
CBE2x Default Gateway
CBE2x Subnet Mask
CBE2x DHCP mode
CBE2x interfaces configuration
Communication via Modbus TCP
6.8 Messages and parameters
181