Configuring Eip Via The X1400 Interface At The Cbe20 - Siemens SINAMICS S120 Series Function Manual

7.5

Configuring EIP via the X1400 interface at the CBE20

To communicate with a higher-level control via EIP, make the following settings for the
CBE20:
1. With p8835 = 4, set the firmware version of "EtherNet/IP".
2. Using p8941, set the IP address for the CBE20.
You can find the currently valid address in r8951.
3. Set the subnet mask using p8943.
You can find the currently valid subnet mask in r8953.
4. Set the standard gateway using p8942.
You can find the currently valid standard gateway in r8952.
5. Set the station name using p8940.
You can find the currently valid station name in r8950.
6. Select the setting "Save and activate configuration" as interface configuration using
p8945 = 2.
7. Save the data using command "Copy RAM to ROM".
Then switch off the drive power supply.
8. Carry out a POWER ON (switch off the Control Unit and switch on again).
Wait until all LEDs on the drive are dark before switching on. Your settings become active
after switching on.
Result:
You have configured interface X1400 of the CBE20 for communication via EIP .
Communication
Function Manual, 12/2018, 6SL3097-5BD00-0BP0
Communication via Ethernet/IP (EIP)
7.5 Configuring EIP via the X1400 interface at the CBE20
187