5.5. Editing a pre-existing program
Pressing the key for editing a pre-existing program
accesses the following menus:
Menu for editing a phase of a pre-existing program
Copying a program
Deleting a program
5.5.1. Modifying a phase of a pre-existing program
Select the icon to edit a phase of a pre-existing program
editable programs.
Select the program to be edited.
In EASY operating mode, having selected the program to edit, follow the same process as that for
programming a new program (Section 5.4. Programming a new program).
Remember that on editing a preset program, only the name of the program can be altered.
In PRO operating mode the programs allow multiple phases. Once the program to be edited has been
selected, the editing submenu will be displayed (Fig. 5.17) which will allow the user to:
Editing a phase
Inserting a phase before the selected phase
Inserting a phase after the selected phase
Deleting a phase
5.5.2. Copying a program
Select the icon for copying a program phase
Select the program to be copied: the source program for the
copy.
Select the number of the new program: The number of the
target program for the copy.
Remember that the new copied program can be edited later.
Edit mode
. The dryer will display a screen with the
. The dryer will display a list of the existing programs.
Edit programs
Fig. 5.16
Edit phases
Copy from
Copy into
Code no. 576074
Rev. nº 03/0418
32
Fig. 5.17
Fig. 5.18
Fig. 5.19