Manual Program. Definition And Use; Stop Modes; Normal Stopping; Stop Due To Opened Door - GIRBAU ED Series Operating And Maintenance Instruction Manual

4.5. Manual program. Definition and use

The MANUAL PROGRAM allows the user to create a custom program for immediate use.
Once this program has been used, all the values programmed are deleted.
Free program
Once selected, the manual program must be programmed by following the steps in the EDIT mode (Chapter 5).
In this program, the "HEATING" option is always on.

4.6. Stop modes

4.6.1. Normal stopping

Pressing the key in the drying stage
If the temperature inside the dryer rises above 60 ºC (140 ºF), pressing the
cooling safety stage. When the internal temperature falls below 60 ºC (140 ºF), the program ends.
If the temperature inside the dryer is below 60 ºC (140 ºF), pressing the
Pressing the key in the cooling stage
During this stage, the
Open the door to finish the program.

4.6.2. Stop due to opened door

Opening the door during the drying stage will cause the rotation to halt and the heating to be turned off.
On re-closing the door, the following information will be displayed on screen:
Continue the
program?
Opening the door during the cooling stage will cause the rotation to halt.
On re-closing the door, the cooling stage will continue.
If the door remains open for more than 10 seconds, the program ends.
Running a program
The option for using the manual program must be enabled
in the OPTIONS menu from the System Tools menu.
(Chapter 7).
Once enabled, the manual program option is displayed after
the top four list on the program selection screen.
If no program has yet been run, the manual program will be
at the beginning of the list of available programs.
key is inoperative.
key situates the program in the
key ends the program.
YES, continue the program.
The program will continue from the point
where it was interrupted.
NO, do not continue the program.
The dryer enters the cooling safety stage.
When the internal temperature falls below 60
ºC (140 ºF), the program ends.
22
Code no. 576074
Rev. nº 03/0418