Advertisement

Quick Links

Installation/Operator Manual
WARNING:
For your safety the
information in this manual must be
followed to minimize the risk of fire or
explosion and to prevent property
damage, personal injury or death.
— Do not store or use gasoline or other
flammable vapors and liquids in the
vicinity of this or any other appliance.
— WHAT TO DO IF YOU SMELL GAS:
• Do not try to light any appliance.
• Do not touch any electrical switch.
• Do not use any phone in your
building.
• Clear the room, building or area of all
occupants.
• Immediately call your gas supplier
from a neighbor's phone. Follow the
gas supplier's instructions.
• If you cannot reach your gas
supplier, call the fire department.
— Installation and service must be
performed by a competent professional.
SLI14D
AVERTISSEMENT: Assurez-vous de
bien suivre les instructions données dans
cette notice pour réduire au minimum le
risque d'incendie ou d'explosion ou pour
éviter tout dommage matériel, toute
blessure ou la mort.
— Ne pas entreposer ni utiliser d'essence
— QUE FAIRE SI VOUS SENTEZ UNE
• Ne pas tenter d'allumer d'appareils.
• Ne touchez à aucun interrupteur. Ne
• Évacuez la pièce, le bâtiment ou la
• Appelez immédiatement votre
• Si vous ne pouvez rejoindre le
— L'installation et l'entretien doivent
Girbau, SA
Carretera Manlleu, KM1
Vic, Barcelona, Spain 08500
Telephone: 34 93 886 1100
Fax: 34 93 886 0785
e-mail: girbau@girbau.es
ni d'autres vapeurs ou liquides
inflammables à proximité de cet
appareil ou de tout autre appareil.
ODEUR DE GAZ:
pas vous servir des téléphones se
trouvant dans le bâtiment.
zone.
fournisseur de gaz depuis un voisin.
Suivez les instructions du
fournisseur.
fournisseur de gaz, appelez le
service des incendies.
être assurés par un professionnel
compétent.
Part No. 113433- 14

Advertisement

Table of Contents
loading

Summary of Contents for GIRBAU SLI14D

  • Page 1 SLI14D Installation/Operator Manual AVERTISSEMENT: Assurez-vous de WARNING: For your safety the bien suivre les instructions données dans information in this manual must be cette notice pour réduire au minimum le followed to minimize the risk of fire or risque d’incendie ou d’explosion ou pour explosion and to prevent property éviter tout dommage matériel, toute...
  • Page 2 ____________________________________________________________________________________________________ Replacement parts can be obtained from your reseller or the Girbau, SA factory. When ordering replacement parts from the factory, you can FAX your order to 34 93 886 0785 or telephone your order to 34 93 886 1100. Please specify the dryer model number and serial number in addition to the description and part number, so that your order is processed accurately and promptly.
  • Page 3: Table Of Contents

    L.C.D. Liquid Crystal Display area where it will be exposed to water and/or L.P. Liquid Propane weather. OSHA Occupational Safety and Health Administration The wiring diagram for the dryer is located behind Underwriters Laboratory the control panel. 113433 -14 girbau@girbau.es...
  • Page 4: Safety Precautions

    66% of its should not be placed in a tumble dryer. rated capacity. Do not dry mop heads. Contamination by wax or flammable solvents will create a fire hazard. Girbau, SA 113433 - 14...
  • Page 5 If the appliance ____________________________________________________________ is converted (gas type is changed), a data plate amendment must be obtained from Girbau. ____________________________________________________________ This appliance may cause spillage of products of combustion from an open-flue appliance fitted in the...
  • Page 6: Specifications

    N / A BOILER HORSEPOWER 1.75 Bhp (NORMAL LOAD) PER POCKET Shaded areas are stated in metric equivalents 9/30/05 NOTE: The manufacturer reserves the right to make changes in specifications at any time without notice or obligation. Girbau, SA 113433 - 14...
  • Page 7 Specifications _____________________________________________________________________ NOTE: The manufacturer reserves the right to make changes in specifications at any time without notice or obligation. 113433 -14 girbau@girbau.es...
  • Page 8: Installation Procedures

    1/16” (1.5875 mm) minimum allowance must be made environment, which the ambient temperature remains for the opening and closing of the control door, along between 40° F (4.44° C) and 130° F (54.44° C). with the removal of panels during maintenance. Girbau, SA 113433 - 14...
  • Page 9: Fresh Air Supply Requirements

    NOTE: Component failure due to dry cleaning solvent fumes will void the warranty. 113433 -14 girbau@girbau.es...
  • Page 10 NOTE 1 Opening from combustible materials must be 2-inches (5.08 cm) larger than the duct (all the way around). The duct must be centered within this opening. NOTE 2 Distance should be 2 times the diameter of the duct to the nearest ____________________________________________________________ obstruction. Girbau, SA 113433 - 14...
  • Page 11: Electrical Information

    IMPORTANT: Failure to comply with these codes or LINE VOLTAGE ordinances, and/or the requirements stipulated in this TERM manual can result in personal injury or component failure. 50 Hz 60 Hz NOTE: Component failure due to improper installation will HIGH void the warranty. 113433 -14 girbau@girbau.es...
  • Page 12 1ø 42.7 1ø 13.5 61.5 — 3ø 13.5 43.3 — 3ø 11.3 35.3 — 3ø 12.4 — 36.5 — 3ø 13.5 37.7 3ø 11.3 22.8 22.6 3ø 12.4 — 23.1 3ø 13.5 — 23.7 11/7/14 Girbau, SA 113433 - 14...
  • Page 13 CAUTION: The dryer must be grounded. A ground lug has been provided for this purpose. ____________________________________________________________ Input connection wiring must be sized properly to handle the dryer’s current draw. This information is printed on the dryer’s ____________________________________________________________ data label. 113433 -14 girbau@girbau.es...
  • Page 14: Gas Information

    For ease of service, the individual gas supply line of each appliance is converted (gas type changed), a data dryer must have its own manual shutoff valve. plate amendment must be obtained from Girbau for CE approved units. Failure to isolate or disconnect the dryer from supply as noted can cause irreparable damage to the gas valve, voiding the warranty.
  • Page 15 *Liquid Propane 2,500 11.0 55,000 16.12 2.184 10.0 Shaded areas are stated in metric equivalents Gas valve’s internal regulator disabled. Information is per pocket/tumbler. *** Consult factory for elevations over 2,000 feet (610 meters) for correct orifice size. 113433 -14 girbau@girbau.es...
  • Page 16: Converting From One Family Of Gas To Another

    (gas type changed), a data appliances on the same line, etc. Specific information plate amendment must be obtained from Girbau regarding supply line size should be determined by the gas (dryer’s serial number is required to purchase a supplier.
  • Page 17 Use a soapy water solution or product intended for that IMPORTANT: Use extreme care when removing and purpose. replacing orifice (injector). This orifice (injector) is made of brass, which is easily damaged. Reinstall the burner tube onto the burner base. 113433 -14 girbau@girbau.es...
  • Page 18: Gas Pressure Testing

    (gas type changed), a data Repeat these steps for the other burner. plate amendment must be obtained from Girbau. Open all shutoff valves, reconnect electrical power to the Conversions done improperly can result in a fire or dryer, and test for leaks.
  • Page 19: Steam Information

    The steam supply line to the dryer must include a 12-inch IMPORTANT: Coil failure due to improper pH level will void (30.48 cm) riser along with a drip trap and check valve. This the warranty. will prevent any condensate from entering the steam coil. 113433 -14 girbau@girbau.es...
  • Page 20: Water Information

    Solenoid valve failure due to hard plumbing connections will void warranty. ____________________________________________________________ The dryer is to be connected to the water mains using a new hose set and the old hose set should not be reused. ____________________________________________________________ ____________________________________________________________ ____________________________________________________________ ____________________________________________________________ Girbau, SA 113433 - 14...
  • Page 21: Preparation For Operation / Start-Up

    (program) selections. If computer program exhausted to the outdoors. changes are required, refer to the computer programming manual, which was shipped with the dryer. • STEAM MODELS – Check to ensure all steam shutoff valves are open. 113433 -14 girbau@girbau.es...
  • Page 22: Preoperational Instructions

    Cool Down Time or Temperature has been reached. At the end of the cycle the L.C.D. display will read “Cycle Done”. Opening the main door will put the computer back into the “Select Cycle” state. Girbau, SA 113433 - 14...
  • Page 23: Routine Maintenance

    Complete an operational check Steam Dryers of all safety devices (lint door/drawer switch, door switches, Clean the steam coil fins. It is suggested that compressed sail switch, and hi-limit thermostats). air and a vacuum cleaner with brush attachment be used. 113433 -14 girbau@girbau.es...
  • Page 24: Data Label Information

    Data Label Information _______________ CE Label Standard Label AGA Label When contacting Girbau, the information on the data label is required to ensure proper service/parts assistance. The data label is located at the upper left rear of the dryer behind the back guard.
  • Page 25 NOTES __________________________________________________________________________________________________________________________ _________________________________________________________________________________________________________________________________ _________________________________________________________________________________________________________________________________ _________________________________________________________________________________________________________________________________ _________________________________________________________________________________________________________________________________ _________________________________________________________________________________________________________________________________ _________________________________________________________________________________________________________________________________ _________________________________________________________________________________________________________________________________ _________________________________________________________________________________________________________________________________ _________________________________________________________________________________________________________________________________ _________________________________________________________________________________________________________________________________ _________________________________________________________________________________________________________________________________ _________________________________________________________________________________________________________________________________ _________________________________________________________________________________________________________________________________ _________________________________________________________________________________________________________________________________ _________________________________________________________________________________________________________________________________ _________________________________________________________________________________________________________________________________ _________________________________________________________________________________________________________________________________ _________________________________________________________________________________________________________________________________ _________________________________________________________________________________________________________________________________ _________________________________________________________________________________________________________________________________ _________________________________________________________________________________________________________________________________ _________________________________________________________________________________________________________________________________ _________________________________________________________________________________________________________________________________ _________________________________________________________________________________________________________________________________ 113433 -14 girbau@girbau.es...
  • Page 26 Part No. 113433 14 - 04/25/16...

Table of Contents