Starting A Program; End Of The Program; Standby Mode At End Of Program - GIRBAU ED Series Operating And Maintenance Instruction Manual

4.3.3. Starting a program

 Select the desired program using the
selection keys. The information related to the
program selected is displayed at the top right of the
screen:
 drying temperature (70 ºC in attached image)
 drying stage time (25 minutes in attached image) /
degree of drying (according to the setting set in the
program).
 Press the START PROGRAM key. After a few seconds the
drum will begin to rotate.
If the ADVANCED USAGE SETTINGS option has been enabled, see Section 4.4.1.
See examples of executing a program in Section 4.3.6.

4.3.4. End of the program

Once the cooling stage has ended, the machine informs the user of the end
of the drying program acoustically and on screen.
Precautions at the end of the drying program
N.B. It is very important:
 To remove the linen from inside the dryer without delay. This will
prevent creases in the fabric and reduce the risk of spontaneous
combustion.
 To clean the lint filter on a regular basis. Lint prevents extraction and
reduces the performance of the dryer. Use the indication for periodic
cleaning of the lint filter in the general settings Configuration menu.
(Section 7.1.1). Further information about cleaning the filter can be
found in Chapter 11.
 The final temperature of the linen can be high. Protect hands with heat-
insulated gloves.

4.3.5. Standby mode at end of program

If the load is not removed immediately on completing the drying program and corresponding cooling phase, the
machine will remain in standby mode. In this state, the machine will rotate the drum every 30 minutes for 1
minute and run the extractor.
The maximum time in standby mode is 120 minutes.
Running a program
and
Start
17
70ºC/25'
Fig. 4.1
Fig. 4.2
Code no. 576074
Rev. nº 03/0418