Altering The Drying Programs; Using Advanced Settings; Specific Modification Of The Program Being Executed - GIRBAU ED Series Operating And Maintenance Instruction Manual

4.4. Altering the drying programs

4.4.1. Using advanced settings

The ADVANCED USAGE SETTINGS can be enabled from the configuration menu. (See Section 7.1.2).
Enabling advanced settings allows direct access to three modes of execution that modify the contents of the
selected program.
Running the program in basic mode: Running the program without any alteration.
Running the program in soft mode:
Running the program in eco mode:
Running in reduced load mode
Once the program to be executed has been selected, the following screen is displayed:
Advanced settings
Important information about EXECUTION MODES
The program EXECUTION MODES are available in all the programs except the manual program.
The eco and soft modes are mutually exclusive.
The eco and soft modes may slightly increase the length of the drying stage.
The half load mode is compatible with any of the eco and soft modes.
While the program is running, an indication of the EXECUTION MODE activated is displayed on the screen.

4.4.2. Specific modification of the program being executed

During the execution of a program, it is possible to modify the following program values: The alteration made
only applies to the program that is running. Once the program has ended, the content will return to the original
values.
Values that can be altered and the range of alteration
Setting
Drying time
Drying temperature
Drum rotation speed
Running a program
Indicated for drying delicate items. Reduce the mechanical action and
controls the temperature to obtain gentle drying.
Reduces energy consumption.
: Indicated when using the dryer with reduced loads.
Programmable
Unit
values
min 2 - 120
ºC 40 - 90
ºF 104 - 194
rpm 25 – 45
Left key: Sequential selection of soft mode,
eco mode, no selection.
Right key: Enabling or disabling half load
mode.
Confirm and start program.
Back to previous menu
Notes
Changing the drying time. This option is only
displayed in programs with control by length of
time.
It does not appear in programs with control by
moisture level.
Drum Speed: each step alters the speed of
the drum by 2 rpm.
The information key can be used to check the
actual speed of the drum (Section 4.3.7).
20
Code no. 576074
Rev. nº 03/0418