Aux Configuration - Danfoss PVED-CLS Startup Manual

Application Guide
PVED-CLS startup guide
Parameter setting
PVED-CLS AUX configuration
Parameter Conditions for value change
P3646, P3719 See
P3647 Set to minimum joystick command in 0.1% needed to switch into joystick steering.
Parameter Conditions for value change
P3650-P3657 See
© Danfoss | October 2018
Navigate to the AUX configuration section via System Navigator > Configuration > AUX Config
The following parameters only apply if AUX is enabled.
PVED-CLS STW configuration on page 23
There are seven subsets of AUX configuration that apply only if an AUX device is selected in parameter
P3240 in the Peripherals Config page:
limitation, Closed loop joystick, and
Approve the parameters by following the steps in
PVED-CLS AUX mini-wheel programs
There are 5 AUX programs for mini steering wheels that each have a similar set of parameters. These are
only used if a mini steering wheel is present.
PVED-CLS Steering wheel programs
AUX Mini-wheel programs, Soft-stop, Anti-jerk, Anti-drift,
Open loop joystick.
PVED-CLS parameter acceptance
on page 23 for configuration details.
Flow
on page 8.
AB285975085591en-000101 | 27