Vehicle Geometry Configuration - Danfoss PVED-CLS Startup Manual

Hide thumbs Also See for PVED-CLS:

Table of Contents

Application Guide

PVED-CLS startup guide

Parameter setting

PVED-CLS vehicle geometry configuration P3421-P3428

Example parameter settings

Parameter

Conditions for value changes

P3421

Set to match type of steering

P3422

Change according to wheel base figure shown below (dimensions measured in mm)

P3424

Change according to wheel base figure shown below (dimensions measured in mm)

P3426

Change according to steer angle figure and formula shown below (measured in degrees)

P3428

Change according to steer angle figure and formula shown below (measured in degrees)

Danfoss | October 2018

Navigate to the vehicle geometry configuration section via System Navigator > Configuration >

Vehicle Geometry

If the parameter change is not described below or conditions are not met, use the default values.

Wheel base

AB285975085591en-000101 | 11

Table of Contents