Table of Contents
Advertisement
4.
Up to 10 alphanumeric characters can be included in a sequential number, in the format 0–9,
a–z, A–Z. For example, Start Number 000 End Number 999. Each position can contain a
character from one of these formats, for example, Start Number 00a00A End Number
99z99Z.
Use any other characters as non-incrementing characters, for example, '.' or '/'. These must
be entered at the same position in both the Start Number and End Number option values, for
example, Start Number 000/000A End Number 999/999Z.
MP65492–1
Chapter 4: Creating and Editing Messages
At the SEQUENTIAL NUMBER menu, you can do the following:
At this option... You can...
Reset Number
Press the [enter] key to reset the Current Number
to the value of the Start Number, and to set the
Repeat Count value to zero.
Current Number View the current number.
Start Number
Enter the value of the first number in the range, for
example, 0000. See the Sequential Number Values
'About' box below.
End Number
Confirm the last number in the range.
Enter the last number in the range, for example,
9999. Overtype the number displayed as required.
For a decrementing number, enter a value less than
the Start Number value.
Interval
Enter the value by which to increment or
decrement. For example, with a start number of
000, an interval value of 2 increments as 002, 004,
006, and so on, and -2 decrements as 999, 997,
995, and so on. The interval value defaults to 1 and
the range is 1 through 127.
No of Repeats
Enter the number of times the sequential number is
printed before the next increment. This value
defaults to 1.
Repeat Count
Displays the number of times the sequential
number has printed with the Current Number
value. Maximum value is No of Repeats value
minus 1.
This value defaults to 0.
Sequential Number Values
Start Number, End Number and Current Number
73
Linx 4900 Operating Manual
Advertisement
Table of Contents
