Linx 4900 Operating Manual page 164

To refill with ink or solvent, do the following:
1. Remove the appropriate filler cap. The white filler cap with the letter
'S' indicates the solvent tank, while the black filler cap with a 'drop'
icon indicates the ink tank.
2. Remove the cap from the filler bottle, and invert the bottle into the
correct filler point as shown below:
3. Press down the bottle to pierce the foil seal, and wait for
approximately 15 seconds to allow the contents to drain into the
system. The "3.03 Ink Low" or "3.04 Solvent Low" warning
disappears from the Status Line.
4. Ensure that the bottle is empty, then remove the bottle and refit the
filler cap.
MP65492–1
Chapter 7: Diagnostics and Maintenance
Solvent
Figure 7-14 Refilling with Ink and Solvent
145 Linx 4900 Operating Manual
Ink
49144