Linx 4900 Operating Manual page 168

5. Using the brush supplied with the printer, gently remove any ink
deposits that will not wash off from the circled area in Figure 7-15,
paying particular attention to the deflector plates (see Figure 7-16
below). Do not use the brush to clean the nozzle:
AREA WITH THE BRUSH.
DO NOT USE THE BRUSH
Ensure that the cleaning brush used is the non-abrasive, solvent
resistant brush supplied with the printer.
6. Let the printhead stand for a few minutes to allow it to dry completely.
You must take particular care to ensure that the space between the
nozzle and charge electrode is free of solvent.
7. Wash the inside of the printhead cover tube with solvent until all ink
has been removed. Use the brush, where possible, to remove ink
deposits that do not immediately wash off. Finish the cleaning with a
wash and allow the cover tube to dry.
8. Refit the printhead in the cover tube and firmly tighten the securing
screw.
MP65492–1
Chapter 7: Diagnostics and Maintenance
CLEAN ONLY THIS
ON THE NOZZLE
Figure 7-16 Cleaning the Printhead with the Brush
(Pigmented Inks Only)
149
49297
ULTIMA ULTIMA
-PLUS -PLUS
Linx 4900 Operating Manual