Linx 4900 Operating Manual page 224

3.05 Over Speed (Print Trigger)
Description:
Cause(s):
Solution:
3.06 Over Speed (Synchronous Data)
Description:
Cause(s):
Solution:
3.07 Over Speed (Asynchronous Data)
Description:
Cause(s):
Solution:
MP65492–1
Appendix D: System Event Messages
Print triggers are occurring faster than the printer can
print; the printer received a second (or false) print
trigger when it is currently printing a message.
Incorrect Print Delay value entered for the Primary
Trigger options High Level, Low Level or Off. See
Chapter 5, 'Changing the System Setup'.
Product sensor generating false triggers due to electrical
disturbance.
Inadequate product sensor for the current application.
Contact your local Linx distributor.
A 'Print Go' signal occurred before the printer could
generate the message data, therefore, printing could not
take place. The printer may have missed printing at least
one message.
This warning indicates that the printer cannot generate
pixels fast enough.
The amount of variable data (such as sequential
numbers) in the message is too high for the current rate
of print triggers.
False trigger from the product sensor.
Contact your local Linx distributor.
A 'Print Go' occurred before the printer could generate
the message data in response to an asynchronous event
(that is, an event other than that used to trigger print).
During printing, the printer may receive an
asynchronous command, which attempts to change the
current message. The printer may assume that the data
has not arrived and ignore the command (depending on
the software setting), in which case it will continue to
print the unchanged message.
The printer has received a command to change the
message during the delay time.
Contact your local Linx distributor.
205 Linx 4900 Operating Manual