Vega VEGAPULS 62 Operating Instructions Manual page 40

4...20 ma/hart two-wire

Hide thumbs Also See for VEGAPULS 62:

Table of Contents

Additonal settings/Sen-

sor length

Additional settings - Re-

set

VEGAPULS 62 • 4 ... 20 mA/HART two-wire

6 Set up with the indicating and adjustment module

Enter the requested parameters via the appropriate keys, save your

settings and jump to the next menu item with the [ESC] and [->] key.

Caution:

If the instrument is used as part of an overﬁll protection system

according to WHG (Water Resources Act), please note the following:

If a linearisation curve is selected, the measuring signal is no longer

compulsorily linear proportional to the level. This must be taken into

consideration by the user, particularly when adjusting the switching

point on the level switch.

With radar sensors with standpipe antenna, the sensor length is

already preset in this menu item. When shortening the standpipe

antenna afterwards, this value must be corrected respectively.

With a reset, all settings despite a few exceptions will be reset. The

exceptions are: PIN, language, lighting, SIL and HART mode.

The following reset functions are available:

Delivery status: Restoring the parameter settings at the time of

shipment from the factory incl. the order-speciﬁc settings. A created

false signal suppression, user-programmable linearization curve as

well as the measured value memory will be deleted.

Basic settings: Resetting the parameter settings incl. special and

laboratory parameters to the default values of the respective instru-

ment. A created false signal suppression, user programmable

linearization curve as well as the measured value memory will be

deleted.

Table of Contents