Vega VEGAPULS 62 Operating Instructions Manual page 36

4...20 ma/hart two-wire

Hide thumbs Also See for VEGAPULS 62:

Table of Contents

Setup/Vessel form

Setup/Vessel height,

measuring range

VEGAPULS 62 • 4 ... 20 mA/HART two-wire

6 Set up with the indicating and adjustment module

The selection "Standpipe" opens a new window in which the inner

diameter of the applied standpipe is entered.

The following options are available when "Bulk solid" is selected:

Through this selection, the sensor is adapted optimally to the

application or the location and measurement reliability under the

various basic conditions is increased considerably.

Enter the requested parameters via the appropriate keys, save your

settings with [OK] and jump to the next menu item with the [ESC] and

the [->] key.

Also the vessel form can inﬂuence the measurement apart from the

medium and the application. To adapt the sensor to these measure-

ment conditions, this menu item oﬀers you diﬀerent options for vessel

bottom and ceiling in case of certain applications.

Enter the requested parameters via the appropriate keys, save your

settings with [OK] and jump to the next menu item with the [ESC] and

the [->] key.

With this selection, the operating range of the sensor is adapted to the

vessel height and the reliability with diﬀerent frame conditions is

increased considerably.

Independent from this, the min. adjustment must be carried out.

Table of Contents