Vega VEGAPULS 62 Operating Instructions Manual page 11

3 Product description
External indicating and
adjustment unit with
HART protocol
External radio unit
Protective cover
Electronics module
Antenna impedance co-
ne
10
It is suitable for measured value indication and adjustment of plics®
sensors and is connected to the sensor with an up to 50 m long, four-
wire, screened standard cable.
You can find further information in the operating instructions
"VEGADIS 61" (Document-ID 27720).
VEGADIS 62 is suitable for measured value indication and adjustment
of sensors with HART protocol. It is looped into the 4 ... 20 mA/HART
signal cable.
You can find further information in the operating instructions
"VEGADIS 62" (Document-ID 36469).
The PLICSMOBILE T 61 is an external GSM/GPRS radio unit for
transmission of measured values and for remote parameter adjust-
ment of plics® sensors. The adjustment is carried out via PACTware/
DTM by using the integrated USB connection.
You can find further information in the operating instructions
"PLICSMOBILE T 61" (Document-ID 32865).
The protective cover protects the sensor housing against soiling and
intense heat from solar radiation.
You will find additional information in the supplementary instructions
manual "Protective cover" (Document-ID 34296).
The electronics module VEGAPULS series 60 is a replacement part
for radar sensors of VEGAPULS series 60. A separate version is
available for each type of signal output.
You can find further information in the operating instructions
"Electronics module VEGAPULS series 60 " (Document-ID 36801).
The antenna impedance cone is used for optimum transmission of
microwaves and for sealing against the process.
You find further information in the operating instructions "Antenna
impedance cone VEGAPULS 62 and 68" (Document-ID 31381).
VEGAPULS 62 • 4 ... 20 mA/HART two-wire