Power/Communication Box Troubleshooting - Rice Lake CLS-M Installation & Service Manual

CLS-M Installation/Service Manual
9.5

Power/Communication Box Troubleshooting

9-36V Power PCB
Battery Power
Connector
Coiled Cable
Connector
Bluetooth Chip
with Antenna
Mac ID Label
The <Prodfont>480 operator label, (see
basic calibration and service instructions for users of the <Prodfont>480. There is also a help line number to call if more
detailed instruction is required.
www.RiceLake.com
90 Visit our website
Figure 9-11. Power/Communication Box Schematic (PN 130551)
Figure 9-12) on the box, provides information about the LED lights in the box and
CLS-M Forklift Scale
Green LED "PWR" LED1
LED indicates COM PCB is receiving power from 9-36v DC board.
Green LED "HB" LED4
LED Indicates heartbeat of the carriage J-Box. If no LED exists, check for
coiled cable damage.
Red/Green LED "RS-232" LED5
Green transmit, Red receive, indicates transmission from carriage j-box
through the communication box. Flashing indicates successful transmis-
sion through coiled cable.
Blue " " LED2
LED to indicate Bluetooth status. Flashing indicates transmission to hand-
held device.
Red/Green "USB" LED3
Flashing indicates USB port is active. Bluetooth communication to hand-
held device is inactive.
Calibration and Service
Move carriage j-box sealing switch to open position, connect USB cable
and wait for device installation. Open CLS-M Revolution Software. When
complete, carefully unplug USB cable, move switch back into closed position.
Contact Information
Call 1-888-225-7597 for dedicated forklift scale
service and support.
Figure 9-12. Power/Communication Junction Box Label (PN 130551 Only)
ON/OFF Switch
Mac ID Label
USB Port
LED lights
PN 125653