Forklift Battery And Cls Installation; Power/Communication Box Introduction; Power/Communication Connection To Junction Box - Rice Lake CLS-M Installation & Service Manual

Cargo lift scale

Hide thumbs Also See for CLS-M:

Table of Contents

1.2.2

Forklift Battery and CLS Installation

Take into consideration that the indicator power source is connected directly to the battery of the forklift. Most

typical is 12 volts for propane, gas and diesel forklifts.

CAUTION

12 volt systems must have a negative ground, ensure the forklift has a negative ground electrical system. The

CLS cannot operate on a positive ground forklift. Refer to the forklift manual to verify grounding requirements.

Standard CLS scales use 9-36 V power supply for use on 12 V batteries. Install the following for electric system forklifts:

PN 166162 – DC-DC Converter, CLS

PN 166161 – Power Line Filter, CLS (for static protection)

1.3

The Power/Communication box transmits data between the scale and the hand-held device. The Mac ID label is used to pair

the CLS Bluetooth

interface with the hand-held device supplied by the customer.

1.4

The Power/Communication box receives data from the junction box through the Interface Cable.

Figure 1-3. Power/Communication Box Schematic (PN 153616)

Figure 1-4. Interface Cable – Power/Communication Box to Junction Box

Introduction

Table of Contents