Power Cable Connection - Rice Lake CLS-M Installation & Service Manual

Cargo lift scale

Hide thumbs Also See for CLS-M:

Table of Contents

3.3

Power Cable Connection

Each installation is unique, depends on model and style of the forklift.

Do not connect the power cable to the power/communication box until battery connection and power hook-up is

CAUTION

complete.

The indicator power source is connected directly to the battery of the forklift. 12 volt systems are typical for

propane, gas and diesel forklifts.

12 volt systems must have a negative ground, ensure the forklift has a negative ground electrical system. The

CLS cannot operate on a positive ground forklift.

Refer to the forklift user's manual for further verification of grounding requirements.

The power/communication box draws its power from the forklift battery. After it is mounted, run the power cable along the

shortest path that provides protection for the cable (away from moving or hot objects and pinch points), to the forklift battery.

Secure the cable at several points with cable ties.

Cable is required to run inside the roll cage tubing, if there are access holes for this purpose, using fish tape. If the cable is run

through a hole in a tube or panel, be sure the cable is protected against chaffing

When routing cables, do not cover any existing labels on the forklift in compliance with OSHA regulations.

WARNING

Avoid running wires anywhere they could potentially be damaged.

IMPORTANT

* Do not let the cable touch or run along anything that gets very hot

* Keep the cable away from moving parts, including control linkages and fan blades

* Do not place the cable where it can be pinched by the compartment cover when closed

* Do not run the cable up against, or directly across the ignition wires

* Do not let the cable come in contact with engine fluids

* Secure the cable with cable ties at several points to prevent movement or loosening

* Inspect the cable often to ensure it has suffered no damage

Power cable must run inside

the overhead guard pillar.

Figure 3-6. Route Power Cable (PN 153616)

Power/Communication Box Hardware Setup

Table of Contents