Table of Contents
Advertisement
4.5
Leveling Forklift Forks
Junction box needs to be in setup mode (See
from a running engine causes inaccurate readings.
1. Place a level on the forks and adjust to 0°.
2. Press Zero Angle.
3. Zero Fork Angle Successful displays. Select OK.
Forks must be level when testing calibration. A degree of tilt in either direction can cause errors when using the
IMPORTANT
scale.
Section 5.2 on page
39). Turn off the forklift after leveling forks, high vibration
Figure 4-31. Zero Angle
Revolution
i
Zero Fork Angle Successful
OK
Figure 4-32. Select Ok
© Rice Lake Weighing Systems ● All Rights Reserved
Revolution® Interface to CLS
X
31
Advertisement
Table of Contents
Troubleshooting
