Revolution Scale Software; Usb Cable To Power/Communication Box; Connect Usb Card To The Iqube2 Junction Box (Pn 164071) - Rice Lake CLS-M Installation & Service Manual

4.3

Revolution Scale Software

4.3.1

USB Cable to Power/Communication Box

1. Turn off power/communication box.
2. Loosen the screws on the power/communication box and remove the cover.
3. Connect the USB cable to the power/communication box.
4.3.2

Connect USB Card to the iQube2 Junction Box (PN 164071)

Use the following steps to connect the USB card:
1. Remove the calibration switch cover from the junction box.
2. Use a standard type A to micro type B USB cable (PN 163898) to connect to the iQube2 junction box and PC.
Power/Communication
box cover
Figure 4-22. Connect USB to Power/Communication Box
Figure 4-23. Micro B USB iQube2 Junction Box Connection
USB connection
USB Connection
© Rice Lake Weighing Systems ● All Rights Reserved
Revolution® Interface to CLS
27