Setup Selection, Programming - Danfoss VLT 3000 Series Product Manual

Parameter description
015
Setup selection,
Programming
(setup program)
Value:
Preprogrammed (Factory Set)
Setup 1 (Setup 1)
Setup 2 (Setup 2)
Setup 3 (Setup 3)
Setup 4 (Setup 4)
( )Setup=Parameter 001
(Set-up=P001)
= Factory setting. Text in ( ) = Display text.
The figures in [ ] are used in bus communication.
®
MG.30.A7.02 - VLT is a registered Danfoss trademark
0.. Operation and display
The menu setup in which to program
[0] (change data) can be selected.
[1]
It is possible to program the 4 menu setups
[2]
independently of which setup the VLT
[3] frequency converter is operating in (se-
[4]
lected in parameter 001). This concerns
programming via the keyboard and the
[5] serial bus (RS485).
Description of choices:
Preprogrammed contains the factory-set
data and can be used as data source if
the other setups are to be brought to a
known status. The language is always
English.
It is not possible to change data once this
setup has been chosen.
Setup 1-4 is 4 individual setups which can
be used as required. These can be pro-
grammed freely, irrespective of which
setup the VLT ® is running in.
Setup = Parameter 001 is the preset value
normally used. This function can be
deselected for access to program during
operation in other setups than the VLT
currently running in.
NB! If data is changed in the setup the
VLT ® is currently running in, the changes
have an immediate impact on the unit's
function. This applies to both parameters
001 and 015.
®
®
is
87