Example 3:
34
Connection examples
START/STOP REVERSING, thermistor built-in motor connected to VLT
Reference: 1 kΩ potentiometer, 0-10 V ~0-100% speed
The following must be programmed:
Function
Parameter no.
Thermistor on terminal 16
®
MG.30.A7.02 - VLT
is a registered Danfoss trademark
NB: Screen for control cables must be
connected as described in the chapter on
EMC-correct installation.
All settings are based on factory settings, but
motor data (parameters 103-105) must be set
according to the motor connected
Parameter value
400
Thermistor
®
frequency converter.