Table of Contents
Advertisement
Section 6
Full functionality of the UBA-USB Tool Suite was
implemented in Software Versions v1.71-16,
v1.76-17, v1.77-17, v1.76-24 and v1.76-13 or later.
However, the download function can only be
accessed on older version of UBA Acceptor Soft-
ware.
The USB Tool Suite Application is available for
download from the JCM Website at:
www.jcmglobal.com/en/support/downloads.aspx
(See Figure 6-25).
Figure 6-25 UBA-USB Tool Suite Opening Screen
Installing the UBA Tool Suite Application
To begin installing the UBA-USB Application pro-
ceed as follows:
1. Open the Folder where the UBA-USB Tool
Suite Application is located on the PC.
2. Extract the compressed files located in the
Folder into a separate named Folder.
3. Double-click on the
install the UBA-USB Tool Suite onto your
PC.
Installing the UBA Device Drivers
NOTE: If the UBA Downloader Program
was previously installed, the Device
Drivers are ready for use.
To install the JCM-UBA Device Drivers perform
the following steps:
1. Connect power to the UBA.
2. Connect a Male "A" to Male "B" USB Cable
between the UBA-USB Port and an open,
unassigned USB Port on the PC.
3. When the PC recognizes that a new device is
attached to it, it will prompt the user to
install the Device Drivers (See Figure 6-26).
4. Mouse-click on the
Button and let the PC automatically search
JCM Part No. 960-000097R_Rev. 3
Universal Bill Acceptor (UBA-1x-SS & UBA-x4-SS/SU) Programming, Calibration & Test
http://
"Setup"
Application to
Screen
Next>
for the Drivers; if located, the PC will imme-
diately install the proper Driver(s). Follow
the prompts presented on the Screen.
Figure 6-26 UBA-USB Driver Install Screen
5. If the Drivers cannot be located, select the
"Install from a list or specific location
(Advanced)"
Radio Button, Mouse-click on
the
Next>
Browse to where the UBA-USB Tool Suite
Program is loaded. The required Drivers
should be in the same Folder.
Connecting the UBA Unit
The UBA can be either installed in a game or on
the Workbench when using the UBA-USB Tool
Suite.
1. Apply power to the UBA.
2. Open the UBA-USB Tool Suite Program
(See Figure 6-27).
Figure 6-27 Re-Opened UBA-USB Tool Suite
Screen
3. Connect the USB Cable between the UBA
and the PC.
4. When communications is established, the
various Form Fields will be filled-in with
data from the UBA Unit (See Figure 6-28).
6 - 8
Screen Button, then
© 2010, JCM American, Corporation
Advertisement
Table of Contents
