Table of Contents
Advertisement
Section 6
Warning: Make sure the External Power
Supply is OFF when connecting the
harness to the UBA. Failure to do so
may cause electrical shock and/or
permanent damage to the equipment.
2. Figure 6-3 illustrates the UBA's DIP Switch,
LED indicators and external port locations.
Figure 6-3 UBA DIP Switch & Port Location
Software Downloading Procedure
Program Installation
The following PC initialization functions are
required prior to downloading software.
1. Create and name a new folder on your PC.
2. Decompress the.ZIP file and save the
expanded file program contents in the file
folder just created.
3. Open the folder and Double-Click on
"Setup.exe" of the expanded UBA Pro-
gram.
4. The UBA Downloader screen shown in Figure
6-4 will appear. Click the
to continue the installation.
Figure 6-4 Initial Setup Screen
JCM Part No. 960-000097R_Rev. 3
Universal Bill Acceptor (UBA-1x-SS & UBA-x4-SS/SU) Programming, Calibration & Test
button
6 - 2
5. Enter a
and
User Name:
fields displayed by the "Customer Identifica-
tion Screen" and Mouse-click on the
Screen Button as shown in Figure
6-5.
NOTE: One of two selections for a
application installer must also be made
below the information fields.
Figure 6-5 Customer Information Screen
6. Confirm the folder name given during Step 1
to install the UBA Downloader and Mouse-
click on the
Next>
as shown in the Figure 6-6 "
Screen.
Folder"
NOTE: If the folder name given during
Step 1 does not appear under the
UBA Downloader To:
the Change...
and find the correct folder on the PC.
Figure 6-6 Destination Folder Screen
7. The
Ready to Install the Program
shown in Figure 6-7 will now appear. If the
folder selection and customer information is
correct, Mouse-click on the
© 2010, JCM American, Corporation
in the
Organization:
Next
Screen Button
Destination
Install
line, Mouse-click on
Screen Button
screen
Next>
Advertisement
Table of Contents
