Table of Contents
Advertisement
Installation/Operation
Table 2-12 lists the Pin Assignments for the CN1
Connector shown in Figure 2-10.
Table 2-12 Optional cc-Talk Conversion Board
Connector Pin Assignments
Connector CN1
Header: S10B-PHDSS(LF,SN) (Nishiuchi)
Contact Type: SPHD-002I-P0.5 (JST)
Housing: PHDR-10VS (Japan Molex)
Recommended Wire: UL1016 AWG#26
JST PHDR-10VS (2mm, 5x2)
Pin No.
1
Interface 12V DC
2
Interface Ground
3
UBA 12V DC
4
Power Ground
5
UBA T
XD
6
UBA R
XD
7
cc-Talk (+)
8
cc-Talk (-)
9
Reset
10
Reset
Optional USB Connector
Table 2-13 list the Optional USB Connector (JAC
Part No. 300-100154) Pin Assignments.
Table 2-13 Optional USB Connector
Pin Assignments
Optional 24 VDC Connector & USB Converter
Header: LY20-10P-DLT1-PSE (JAE)
Housing: LY10-DC10 (JAE)
Contact Type: LY10-C2-5-10000 (JAE)
Recommended Wires: Pin No. 1 & 6 = UL1061
AWG #26; Pin No. 4 & 5 = UL2547 AWG #26;
Pin Nos. 7 - 10 = UL2854 AWG #28
LY10-DC10 (JAE) (2mm, 5x2)
Pin No.
1
+24V DC Input Power
2
+12V DC Input Power
3
Power Ground
4
+12V (+13V) DC Input Power
5
Power Ground
6
+12V (+13V) DC Input Power
7
V Bus
8
- Data
9
+ Data
10
Ground
JCM Part No. 960-000097R_Rev. 3
Universal Bill Acceptor (UBA-1x-SS & UBA-x4-SS/SU)
Signal Name
Signal Name
Jumper Configurations
The 5 Volt DC UBA CPU Board contains three
jumper plugs. Photo-coupler isolation and/or
RS232C selection is configured by these jumpers.
All three jumpers must be configured to the same
setting (See Figure 2-11).
NOTE: Jumper Settings for Photo-coupler
isolation and RS232C communications are
shown correctly set.
Figure 2-11 5V DC CPU Board Bottom View
The 3.3 Volt DC UBA CPU Board also contains
three jumper plugs, but they are adjacent to one
another. Photo-coupler isolation and/or RS232C
selection is also configured by these jumpers. All
three jumpers must be configured to the same
setting (See Figure 2-12).
NOTE: Jumper Settings for Photo-coupler
isolation and RS232C communications are
shown correctly set.
Figure 2-12 3.3V DC CPU Board Bottom View
Retrieving Banknotes
To retrieve Cash Box deposited Banknotes,
perform the following steps:
1. Pull the handle to release the Cash Box from
the frame as illustrated in Figure 2-13. Press
thumb on the Acceptor Head while pulling
the Cash Box Handle for better leverage
during extraction.
© 2010, JCM American, Corporation
2 - 9
Section 2
Advertisement
Table of Contents
