Table of Contents
Advertisement
Disassembly/Reassembly
2. Remove the E-Clip retaining the small
torque transfer gear (See Figure 4-11 b &
c
, then remove both the small and large
1)
gears from the assembly (See Figure 4-11 c
& c
.
2)
3. Using a finger, pull back on the spring
loaded Roller Guide Home Lever
(See Figure 4-11 d
Roller Guide up and out of the assembly
(See Figure 4-11 d
4. Turn the UBA Acceptor Unit upside-down.
5. Remove the single Encoder Sensor Board
mounting screw and remove the Circuit
Board from the assembly (See Figure 4-12
a).
NOTE: When reassembling the Unit, align
the dents located on the Stacking Gear
Motor as shown in Figure 4-12 b
6. Remove the two (2) Motor Mount Screws
from the right side of the Unit (See Figure 4-
12 b
).
2
7. Remove Stacking Motor from the right side
of the Unit in the direction of the large down
pointing arrow shown in Figure 4-12.
Figure 4-12 Stacking Motor Removal
8. Align the gear of the Clutch Spring Stopper
as shown in step
(c
and screw (c
2)
and lift them up and out of the assembly.
NOTE: When remounting the Stacking
Motor, be sure to rotate the dents on the
Motor in the direction shown in Figure 4-12
before re-inserting it.
JCM Part No. 960-000097R_Rev. 3
Universal Bill Acceptor (UBA-1x-SS & UBA-x4-SS/SU)
step
) and pull the
1
step
).
2
step
1
c
, then remove E-Clip
1
retaining the two gears,
3)
NOTE: The Stacking Motor Gear and the
Clutch Spring Stopper must be realigned as
shown in Figure 4-12 before remounting the
Stacking Motor!
1
9. Turn the UBA Acceptor Unit upside-down
again.
10. Remove the Stacking Clutch Shaft retaining
E-clip and Bushing (See Figure 4-13 a), then
pull the assembly downward and out of the
Unit in the direction of the large down point-
ing arrow shown in Figure 4-13.
.
Figure 4-13 Stacking Clutch Shaft Removal
11. Turn the UBA Acceptor Unit upside-down a
third time as shown in Figure 4-14.
Figure 4-14 Right Guide Mounting Screw
4 - 5
a)
Removals
© 2010, JCM American, Corporation
Section 4
Advertisement
Table of Contents
