Table A-2 Adjustment Fault Conditions - JCM GLOBAL UBA Series Operation And Maintenance Manual

Troubleshooting
Symptoms/Error
Possible Fault Causes
Messages
A foreign object or a jammed
bill is stuck in the Transport
Motor
continues to run.
Can not enter the
TEST mode.
Symptoms/Error
Possible Fault Causes
Messages
Can not start the
PC Operating System (OS)
ADJTOOL_V***
.exe program by
double-clicking on its
icon.
Communication
Error.
Adjustment Error.
Upper/Lower Sensor Board
JCM Part No. 960-000097R_Rev. 3
Universal Bill Acceptor (UBA-1x-SS & x4-SS-SU)
Table A-1 General Fault Conditions (Continued)
Upper Guide is open.
path.
Motor driver failure.
Incorrect DIP Switch
settings.
Dip switch failure.
CPU Board failure.

Table A-2 Adjustment Fault Conditions

is not compatible.
The program files are
corrupted.
Wrong or inappropriate
connections
UBA DIP Switch
settings are incorrect.
DIP Switch failure.
CPU Board failure.
Incorrect reference
paper type.
failure.
Corrective Action Required
Firmly close the guide.
Open the Guide, remove the foreign object or jammed bill, and
close the cover.
Refer to the "No. 1 Transport Motor Forward/Reverse Rotation
Test" on page A-5 of this Appendix and conduct a Forward/
Reverse Motor Rotation Test.
Set the DIP Switch No. 8 to ON, and resupply power
to the UBA.
Refer to the "No. 9 DIP Switch Test" on page A-11 of this
Appendix and conduct a DIP Switch TEST to check if the
specific DIP Switch Block has a failure.
Exchange the CPU Board with a known good board. Refer to
"CPU Board Removal" on page 4-3 of Section 4 of this Manual
regarding Circuit Board Removal.
Corrective Action Required
The current Adjustment program only supports the
Windows 2000/XP Operating System.
Request the correct programs from JCM.
Check the PC harness connections and the related UBA
interface connectors. Check for any bent, missing or
damaged pins in the connector plug and receptacle.
Set the UBA DIP Switches 1 to 7 OFF and Switch 8 to ON.
Recycle the power supplied to the external maintenance power
supply (P/N 702-000148).
Refer to the "No. 9 DIP Switch Test" on page A-11 of this
Appendix and conduct a DIP Switch Test.
Exchange the CPU Board with a known good one. Refer to
Section 4 regarding Circuit Board Removal.
Follow the instruction provided in the ADJTOOL_V***.exe
program and use the correct reference paper recommended.
Change the Upper or Lower Sensor Board with a known good
board. Refer to Section 4 regarding Circuit Board Removal.
A - 3
Appendix A
© 2010, JCM American, Corporation