Table of Contents
Advertisement
General Information
Specifications
Technical Specifications
Acceptance rate:
Banknote Types Accepted:
Insertion Direction:
Processing Speed:
Diagnostic Indicators:
Escrow:
Anti-stringing Mechanism:
Cash Box Capacity:
Interface:
Environmental Specifications
Operating Temperature:
Storage Temperature:
Relative Operating Humidity:
Relative Storage Humidity:
Visible Light Sensitivity:
Installation:
Electrical Specifications
Supply Voltage:
Current Consumption:
Structural Specifications
Weight:
Mounting:
Outer Dimensions:
JCM Part No. 960-000097R_Rev. 3
Universal Bill Acceptor (UBA-1x-SS & UBA-x4-SS/SU)
Table 1-2: UBA-1x Technical Specification
Refer to the specific Country's Banknote Specifications when considering
the following Parameters:
98% or greater*
*Note: The following Banknotes types are excluded:
a) Banknotes with excessive or poor magnetism or unclear graphics
b) Double (dual) notes
c) Worn, dirty, wet, torn or excessively wrinkled Banknotes
d) Banknotes having folded corners or edges
e) Banknotes having the wrong cut dimensions or printing displacement
f) When security measures against counterfeiting are implemented, the software
may not fulfill the specified acceptance rate level.
Width: 2.44 – 3.35 in. (62 – 85mm), Length: 4.72 – 6.5 in. (120 – 165mm
to 6.7 in. (170mm) when using a WBA Steel Cash Box]
Refer to the specific Country's Banknote Specifications relative to the
Banknote Types being used
Approximately 2 seconds (from Banknote insertion to Vend Signal output)
Approximately 5 seconds (from Banknote insertion to stacking completion )
Front Panel Faceplate LEDs
1 Banknote
Pull-Back (PB) Unit (anti-pullback system – JCM Patented)
500 notes or more
USB 2.0 Compatable (full speed transfer [120 bps])
ID-003 JCM Standard Serial Interface (UBA-10/11/12)
ID-024 OEM Interface
ID-028 JCM USB Serial Interface (UBA-14/24)
(Ask JCM for the proper communication specification for your Unit)
Contact JCM for other Interface requirements if required.
Table 1-3: UBA-1x Environmental Specification
41ºF to ~ 122ºF (5ºC to ~ +50ºC)
- 4ºF to ~ 140ºF (-20ºC to ~ +60ºC)
30% to ~ 85% RH (non-condensed)
30% to ~ 86% RH (non-condensed)
Avoid Direct Sunlight Contact
Indoors Only
Table 1-4: UBA-1x Electrical Specification
12VDC ± 5%
(NOTE: Use a power supply with a 4.0A or more capability)
A 24VDC to12VDC conversion board option is available.
Standby = 300mA
Operation = 1.6A
Table 1-5: UBA-1x Structural Specification
Approximately 8.81 lbs (4.0kg)
Horizontal
11.73 in (298mm) High x 8.86 in (225mm) Deep x 4.49 in (114mm) Wide
1 - 5
)
© 2010, JCM American, Corporation
Section 1
[up
Advertisement
Table of Contents
