Connector Pin Assignments (Continued 2); Table 2-4 Uba-24 Rear Panel Connector Pin Assignments - JCM GLOBAL UBA Series Operation And Maintenance Manual

Installation/Operation

Connector Pin Assignments (Continued 2)

Table 2-4 lists the UBA-24 Rear Panel Connector Pin Assignments.
Pin
Signal Name
No.
1 +12V POWER
2 GROUND (Power)
3 M. RES
4 NC
5 +12V I/F
6 NC
7 NC
8 Vbus
9 -DATA
10 +DATA
11 NC
12 GND USB
13 NC
‡
14 LED POWER
15 NC
16 NC
17 NC
18 LED- (TTL2)
19 NC
20 NC
**
*. Signal name, I/O, and function with parenthesis are for photo-coupler isolation and RS-232C only.
†. I/O (input/output) is the terminal viewed from Bill Acceptor's side.
‡. Short to Pin 20 for use as an SU Unit.
**.Short to Pin 13 for use as an SU Unit.
JCM Part No. 960-000097R_Rev. 3
Universal Bill Acceptor (UBA-1x-SS & UBA-x4-SS/SU)

Table 2-4 UBA-24 Rear Panel Connector Pin Assignments

UBA-24 Rear Panel Connector
Socket Jack: DRA-20PC-FO (JAE)
Contact Type: D02-22-26P-10000 (JAE)
Socket Plug: DRA-20SC-FO (JAE)
Contact Type: D02-22-26S-10000 (JAE)
* †
I/O
+12V DC power
0V DC Ground Plain
In Bill Acceptor's master reset signal line
Reserved
+12V DC Interface Power
Reserved
Reserved
USB Communication Vbus signal line: DC +5V
IN/OUT USB Communication input/output signal line
IN/OUT USB Communication input/output signal line
Reserved
USB Communication Ground: DC 0V
Reserved
LED drive line - anode
Reserved
Reserved
Reserved
LED Drive Line - cathode
Reserved
No Connection
Function
© 2010, JCM American, Corporation
2 - 5
Section 2