Led Reject Codes; Table A-15 Led Reject Codes - JCM GLOBAL UBA Series Operation And Maintenance Manual

Troubleshooting

LED Reject Codes

Table A-15 lists the possible LED Reject Codes that can exist when a fault condition occurs.
LED Status
Red LED Green LED
OFF 1 Flash
OFF 2 Flashes
OFF 3 Flashes
OFF 4 Flashes
OFF 5 Flash
OFF 6 Flashes
OFF 7 Flashes
OFF 8 Flashes
OFF 9 Flashes
OFF 10 Flashes
OFF 11 Flashes
OFF 12 Flashes Banknote feed error Check all bill path sensors.
OFF 13 Flashes
OFF 14 Flashes
OFF 15 Flashes
If diagnostic LED status is different from
the Table A-15 listed states, contact JCM
Technical Support.
JCM Part No. 960-000097R_Rev. 3
Universal Bill Acceptor (UBA-1x-SS & x4-SS-SU)

Table A-15 LED Reject Codes

Error
Slanted Bill Insertion Re-insert the bill straight.
Check all lenses for dirt or scratches. To clean the
lenses and sensor, refer to Section 2 regarding
Magnetic Sensor Preventive Maintenance. An Upper Sensor Board
pattern error failure may have occurred. Check all harnesses and
connectors. To change the Upper Sensor Board refer to
Section 4 regarding Circuit Board Removal.
Paper detected Remove the paper jam from the Acceptor path and
inside the Acceptor clean the lenses. To clean the lenses and sensor, refer
in standby mode to Section 2 regarding Preventive Maintenance. An
Upper and/or Lower Sensor Board failure may have
occurred. Check all harnesses and connectors. To
Optical Sensor level
change the Upper/Lower Sensor Board, refer to
error
Section 4 regarding Circuit Board Removal.
Banknote movement error (Timing). Check for worn or
Banknote feed error
dirty Belts, poor quality Banknotes or Debris in the Bill
Type 1
Transport Path.
Banknote identif-
Remove the Bill from the Acceptor and clean the
ication error
lenses. To clean the lenses and sensors, refer to
Section 2 regarding Preventive Maintenance. An Upper
Barcode Read
and/or Lower Sensor Board failure may have occurred.
error
Check all harnesses and connectors. To change the
Upper/Lower Sensor Board, refer to
Double Note or
Section 4 regarding Circuit Board Removal.
Ticket error
Check and set DIP switches properly. Refer to Section
Inhibited Bill 1 regarding Component Names, and Section 6
referencing Software Specifications/Requirements.
Return Bill Bill inhibited by host machine.
Reserved N/A
Check all belts and rollers in the Transport path. To
clean the belts and rollers, refer to Section 2 regarding
Banknote length
Preventive Maintenance. To change the belts and
error
rollers, refer to Section 4 regarding Disassembly
Instructions.
Rear Banknote jam Remove the Banknote from the Acceptor and clean the
error lenses. To clean the lenses, refer to Section 2
regarding Preventive Maintenance. An Upper and/or
Lower Sensor Board failure may have occurred. Check
UVSensor
all harnesses and connectors. To change the Upper/
error
Lower Sensor Board, refer to Section 4 regarding
Circuit Board Removal.
A - 1 5
Causes and Solutions
© 2010, JCM American, Corporation
Appendix A