Installation/Operation; Installation; Figure 2-1 Front Panel Dip Switch Block; Figure 2-2 End Mounting Screw Hole Locations - JCM GLOBAL UBA Series Operation And Maintenance Manual

Universal Bill Acceptor (UBA-1x-SS & UBA-x4-SS/SU)

2 INSTALLATION/OPERATION

This section provides installation and operation
instructions for the Universal Bill Acceptor Series
(UBA). The information within contains the
following features:

• Installation

• Lock Installation
• DIP Switch Configurations
• Connector Pin Assignments
• Jumper Configurations
• Retrieving Banknotes
• Clearing a Banknote Jam
• Cleaning/Preventive Maintenance
• Operational Flowchart
• Interface Circuit Schematic
Installation
Perform the following steps to install the UBA
unit:
1. Remove power from host machine.
2. Set UBA DIP Switches if required
(See Figure 2-1). The initial setting is all
switches OFF to enable all denominations.

Figure 2-1 Front Panel Dip Switch Block

3. Connect the proper interface harness from
the host machine to the UBA.
4. Install the UBA into the host machine using
Flat Head M4 mounting screws. There are
four mounting holes located on the frame
end and three located on each side of the
frame (See Figure 2-2 & Figure 2-3).
NOTE: The maximum
length of M4 Flat Head
Screws should be 4mm
plus the thickness of the
cabinet or mounting
bracket. Example: If the
UBA is mounted on a bracket that is 2mm
thick, the M4 screws should be no more
than 6mm in length.
JCM Part No. 960-000097R_Rev. 3
UBA® Series
S e c t i o n 2

Figure 2-2 End Mounting Screw Hole Locations

Figure 2-3 Side Mounting Screw Hole Locations

5. Apply power to the machine and verify that
the Circuit Board mounted Red Chip LED,
located to the left of the DIP Switch Block,
is illuminated (ON) (See Figure 2-4), and
both the Red and Green frame mounted
Front Panel Indicator LEDs are extinguished
(OFF).

Figure 2-4 Circuit Board Mounted Red LED

2 - 1
© 2010, JCM American, Corporation