Icb Module Removal; Cash Box Sensor Board Removal; Pusher Mechanism Unit Disassembly; Figure 4-35 Cash Box Handle Removal - JCM GLOBAL UBA Series Operation And Maintenance Manual

Section 4

Figure 4-35 Cash Box Handle Removal

ICB M R
ODULE EMOVAL
Perform the following steps to remove the UBA
ICB Module:
1. Remove the two (2) module mounting
screws securing the ICB Module Box Cover
to the ICB Module Box Assembly
(See Figure 4-36 a).

Figure 4-36 ICB Module Removal

2. Remove the two (2) screws that mount the
ICB Module Box onto the Cash Box
(See Figure 4-36 b).
3. Remove the two (2) screws that attach the
ICB Module circuit board onto the ICB
Module Box Assembly (See Figure 4-36 c).

Cash Box Sensor Board Removal

1. Remove the Transport Guide E Back Cover
by pressing down on the curved arrow area
indicated in Figure 4-37a.
2. Remove the two (2) Cash Box Sensor Board
mounting screws (See Figure 4-37 b).
JCM Part No. 960-000097R_Rev. 3
Universal Bill Acceptor (UBA-1x-SS & UBA-x4-SS/SU)
4 - 1 2

Figure 4-37 Cash Box Sensor Removal

3. Carefully lift the Cash Box Sensor Board up;
disconnect its Harness Connector Plug, and
remove the Cash Box Sensor Board from the
Transport Guide E Assembly.

Pusher Mechanism Unit Disassembly

Perform the following steps to disassemble the
UBA Pusher Mechanism Unit:
1. Open the Cash Box lid and remove the two
(2) internal Pusher Mechanism Unit Mount-
ing Screws from the back inside wall of the
Cash Box (See Figure 4-38).
2. Slide the Pusher Mechanism Unit out of the
assembly in the direction of the large arrow
in Figure 4-38.

Figure 4-38 Pusher Mechanism Unit Removal

3. Remove the six (6) Pusher Mechanism
Mounting Screws from the sides of the
assembly as shown in Figure 4-39.
4. Separate the Pusher Mechanism Unit upward
and out of the Transport in the direction of
the large arrow in Figure 4-39.
© 2010, JCM American, Corporation
Disassembly/Reassembly