Table of Contents
Advertisement
General Information
Use a soft, lint-free cloth and a mild non-
abrasive soap and water solution to clean
dust and debris from the Banknote's path.
Under no circumstances allow the cloth
to be wet enough to allow excess fluid
to run into the device; internal Printed
Circuit Boards may be damaged. Do not
use any Alcohol, solvents or scouring
agents which can attack the plastic
surfaces of the device.
A new JCM authorized Waffletechnology
Cleaning Card is now available for quick
cleaning of the UBA Unit. Refer to page 2-
UBA-10/11/12 Component Names
Figure 1-3 illustrates the UBA-10/11/12 Primary Component Parts and their relative locations.
A: Acceptor Unit
B: Upper Guide Access Lever
C: Front Access Door
D: Acceptor Unit Release Lever
E: SS Style Cash Box
F: USB Type B Male Receptacle for software
downloading and adjustments
G: DIP Switch Block (See Table 2-1on page 2-2 of
Section 2 to properly set these Switches)
H: Diagnostic LEDs
(Green & Red)
and Table A-15 in Section Afor the proper
Diagnostic Codes)
Figure 1-3 Universal Bill Acceptor (UBA-1X-SS) Major Component Parts
JCM Part No. 960-000097R_Rev. 3
Universal Bill Acceptor (UBA-1x-SS & UBA-x4-SS/SU)
See Table A-13
1 - 3
11 of Section 2 of this Service Manual for
more information on using the Waffletech-
nology Cleaning Card.
8. Inserting worn or damaged Banknotes may
cause a jam. If a jam occurs when the Cen-
tering Mechanism is closed, the Cover will
not open. To unjam the Unit when in this
condition, recycle Power to allow the Unit to
reset. Refer to "Clearing a Banknote Jam" on
page 2-10 of Section 2 of this Service Man-
ual for more information on clearing Ban-
knote jams.
I: Front Bezel Connector
(Connects to the Faceplate Assembly)
J: Interface Connector
(Connects to the Host Machine)
K: Centering Guide Release Port
L: Housing Frame
M: Key Spacer (2 each)
N: Plate Locking Key (2 each)
O: Key Hole Cap.
© 2010, JCM American, Corporation
Section 1
(on both sides)
Advertisement
Table of Contents
