Activating And Deleting Already Existing Nc Software - HEIDENHAIN TNC 426 PB/M Technical Manual

Table of Contents

Activating and

deleting already

December 2001

Complete or erase the machine parameters. Information about the machine

parameters can be found on the READ_MP.A file on the first provided setup

disk, or on the TNC in the directory PLC:\JH\.

Exit the machine parameter editor: Press the END key. The message

LANGUAGE LOAD ERROR appears.

On the TNC, switch to the PROGRAMMING AND EDITING mode of

operation and press the MOD key.

Enter the code number 95148 and confirm with ENT.

In the machine-parameter-editing mode of operation, press the MOD key.

Convert updated data to binary format: Press the soft key UPDATE DATA

and CONVERT ASC -> BIN. The name of a log file may also be entered.

Read-in files which you had saved to a PC.

End of the NC software switch.

With the COPY SAMPLE FILES soft key, the cutting data tables, the tables

for tilted-axis geometry, and the table of M-function macros can be copied

into the corresponding directory.

For controls with flash EPROMs, each new NC software is saved to its own

directory in the SYS partition.

For controls with EPROMs, only the contents of the setup disks are copied

to the appropriate directories. The NC software automatically chooses the

correct setup.

You can also delete setups that are no longer needed with the procedure

detailed below:

To activate already existing NC software:

While in the Programming and Editing operating mode, press the MOD key.

Enter the code number 95148.

Press the MOD key.

Press the UPDATE DATA soft key.

Press the DEL/SEL SETUP soft key.

Use the arrow keys to select the desired NC software.

Press the SELECT soft key.